Description
Explore the dual rotary encoder with push switch from PropWash Simulation. Review the product details below to choose the right hardware for your cockpit.
Dual Concentric Rotary Encoders with Push Switch used on radio panels, GNS430 simulation or anywhere you need 2 encoders with a switch in a small area. Great for Flight Simulation applications! These encoders are built specifically for PropwashSim.com!
Encoder has an included breakout board and headers.
Headers included may be a different color than pictured.
Sold as a kit only. Simple soldering skills required
-
Dual Encoder w/switch
-
20 detents per revolution
-
2 pulses per detent (type 2 encoder)
-
Shaft Diameters: 3.5mm/5mm
-
Lifespan – up to 300,000 revolutions
-
Built to FAA standards (not certified)
INCLUDES:
-
Encoder
-
Nut and washer for mounting
-
Printed circuit board
-
Male Headers (may be different color than pictured)
-
Black or Grey knobs
Dual rotary encoder with push switch: setup and selection
Plan the encoder installation
Use the concentric shafts when two adjustments must fit into one control position. Before drilling a faceplate, check shaft clearance, knob spacing, and room behind the panel for the breakout board. This is a kit and requires simple soldering skills. Confirm the encoder type in your controller software and test both rotation directions and the push switch before mounting it.
Resources and help
Compare single encoder kits and visit our software and installation downloads. For help choosing a dual rotary encoder with push switch, contact PropWash with your simulator, aircraft, and project details.
For additional background, see the official Arduino documentation. Third-party resources supplement the product-specific requirements above.






